Irrigation Intelligence
Precision Water Control.
Zero Waste. Maximum Yield.
Real-time soil field-capacity monitoring, IoT-triggered irrigation scheduling, and FAO Penman-Monteith ET₀ modelling — fused into a single decision layer. VersaAgro identifies under- and over-irrigation events before yield damage occurs.
Sentinel-2 NDWI Layer
14 IoT Soil Sensors
FAO ET₀ Model
Auto-Schedule Engine
−34% Water Applied
18%
Jalisco FC
84%
Nebraska FC
2
Critical Zones
−34%
Water Saved
Portfolio Water Balance
62/100
↓ −8 pts in 72h · 2 fields Watch
Active Irrigation Runs
3 zones
Jalisco Sector 2 · 3 · 5 running
Water Applied Today
1.24 ML
↑ 12% vs. AI recommendation
ET₀ Demand Today
6.2 mm
High evapotranspiration · 34°C forecast
Zone 1 · 18% FC ⚠
Zone 2 · Running 💧
Zone 3 · 78% FC ✓
Zone 4 · 38% FC ~
Zone 5 · Running 💧
Zone 6 · 91% FC ✓
Zone Status
Critical (<20% FC)
Watch (20–40% FC)
Active — Irrigating
Optimal (60–100% FC)
IoT Sensor Fusion · May 13, 2026 · 09:14 UTC
Moisture History
May 7May 8May 9May 10May 11May 12May 13
Soil Field Capacity — All Zones (7-day)
IoT Real-time
ET₀ Demand vs. Water Applied (mm)
FAO PM Model
Water Balance Index — Jalisco Blue Agave
Critical Field
18
% FC
Field Capacity18% — CRITICAL
Target FC Range60–80%
Irrigation Line Failure Suspected — Sensor SNS-MX-011 reads 18% FC despite scheduled drip run at 06:00. NDVI drop −0.24 in 14 days confirms stress. Estimated $48,000 yield risk.
Season Water Efficiency
34%
Water Saved
vs. fixed schedule
0%
Yield Loss
Zero suppression
+12%
N Uptake
Efficiency gain
AI Irrigation Recommendations
4 actions
1
Dispatch field technician — inspect drip lines & SNS-MX-011
Sensor reads 18% FC despite 06:00 scheduled run. Physical line rupture at GPS 20.6°N, 103.4°W suspected. Confirm before triggering emergency tank draw.
2
Activate Tank B3 emergency allocation — 340,000 L to Zone 1
If line rupture confirmed, bypass Sector 1 drip and supply via overhead emergency valve. Blue Agave Year 4/8 — stress during this stage is irreversible.
3
Shift Zone 4 schedule to 04:00–05:30 — avoid midday ET₀ loss
Zone 4 at 38% FC with 6.2 mm ET₀ forecast today. Early-morning scheduling reduces evaporative loss by ~22% vs. current 11:00 slot.
4
Re-scan with Sentinel-2 NDWI in 72h to validate recovery
After intervention, request next NDWI composite pass to confirm field capacity recovery across all critical zones before resuming normal schedule.
IoT Soil Moisture Sensors — Jalisco Blue Agave
14 Active
Irrigation Schedule — Today May 13, 2026
| Zone | System | Start | Duration | Volume (L) | ET₀ Need (mm) | Status | Actions |
|---|
Feature Feedback
How is VersaAgro's Irrigation Intelligence working for your operation?
Your ratings shape our roadmap. Tell us what's working on the ground and what needs improvement — every vote feeds our product sprint cycle directly.
Auto-Scheduling
Sensor Accuracy
ET₀ Model
Alert Timing
Water Savings
Dashboard UX
Pivot Integration
Reporting
Working Well
Accurate, timely, saves water & yield
247
Needs Improvement
Gaps, latency, or accuracy issues
31
FAQ
Irrigation Intelligence — Common Questions
Answers for agronomists and farm operators using VersaAgro's water balance and scheduling module.
How does VersaAgro calculate when to trigger an irrigation event?
VersaAgro fuses two trigger signals: (1) IoT soil moisture sensors reporting Volumetric Water Content (VWC) against your crop's defined Field Capacity thresholds — a "Watch" advisory fires below 35% FC and a "Critical" alert fires below 20% FC — and (2) FAO Penman-Monteith ET₀ modelling that calculates daily crop water demand based on temperature, solar radiation, humidity, and wind speed from the nearest weather station. When the IoT signal falls below threshold AND the ET₀ demand exceeds replenishment rate, the Auto-Schedule Engine generates an optimised irrigation event with start time, duration, and volume calculated to restore FC to your target range without over-watering.
What is the 34% water saving figure based on?
The 34% figure comes from a 14-week trial across five hydroponic allium blocks where VersaAgro's dynamic field-capacity threshold triggers replaced fixed irrigation schedules. Water applied per kilogram of yield dropped by 34% with zero yield suppression and a 12% improvement in nitrogen uptake efficiency. The savings derive from three mechanisms: eliminating pre-emptive irrigation when soil is already adequate; scheduling runs at low-ET₀ periods (pre-dawn) to reduce evaporative loss by ~22%; and catching line failures early before they trigger compensatory over-watering on adjacent zones.
How is an irrigation line failure detected without a physical inspection?
Line failures are detected through a convergence of three signals: the affected IoT sensor(s) fail to show expected FC rise after a scheduled irrigation run; the Sentinel-2 NDWI composite shows no corresponding increase in canopy water content in the expected window; and the NDVI rate-of-change in that field zone begins diverging from the surrounding healthy baseline. This three-way signal convergence is what distinguishes a genuine irrigation failure from a sensor calibration drift or temporary communication loss. The alert is only fired when all three signals align — minimising false positives while catching real failures within 24–48 hours of onset.
Does VersaAgro integrate with existing pivot control and drip valve systems?
Direct API integration with John Deere Operations Centre and Lindsay Zimmatic pivot control is on the 2025 GA roadmap. In the current pilot phase, the scheduling output is delivered as structured JSON payloads exportable to most FMIS and SCADA systems via REST webhook. Drip irrigation systems with Modbus-TCP or MQTT-enabled valve controllers can be connected through the VersaAgro IoT Edge Gateway. The alert remediation documents include application rate guidance, optimal timing windows, and estimated cost-benefit analysis formatted for direct import into John Deere Ops Centre, Trimble Ag Software, and SAP AgriStar.
What crops and irrigation system types are supported?
VersaAgro's irrigation module supports all major crop types tracked by the platform — including row crops (soy, maize, wheat), tree crops (coffee, olive, citrus), succulent crops (Blue Agave), and controlled-environment horticulture (hydroponic alliums, leafy greens). System types supported include subsurface drip (SDI), surface drip, overhead pivot, micro-sprinkler, and flood/furrow (with manual run confirmation). Crop-specific thresholds for FC, CWSI, and ET₀ coefficient (Kc) are pre-loaded from FAO-56 and updated with local calibration data from your deployed sensor network over time.